Clopay 0120040 Narrow Garage Door Hinge #4 – 18-Gauge Galvanized Steel
Narrow 2-inch #4 replacement hinge for compatible residential sectional garage doors. Designed to maintain proper upper-section roller and track spacing.
The Clopay 0120040 #4 hinge connects adjacent garage door sections and holds the side roller at the correct offset. Its 18-gauge galvanized steel construction provides dependable support and corrosion resistance.
Key Features
- Clopay part number 0120040
- Narrow-body #4 garage door hinge
- 18-gauge galvanized steel
- Approximately 2" wide and 7-5/8" long
- Approximately 2-1/4" roller carrier
- Typical position between the fourth and fifth door sections, when applicable
- Roller and mounting fasteners not included
- Sold individually
Typical Installation Position
A #4 hinge is commonly used at a higher section joint than #1, #2, or #3 hinges. It provides additional roller offset to maintain proper spacing between the upper door section and vertical track.
Compatibility:
Numbered hinges are not interchangeable. Confirm the original part number, hinge number, width, mounting-hole pattern, and roller position before ordering.
Safety:
Close and secure the garage door and disconnect the opener before replacing hinge hardware. Do not loosen bottom brackets, lift cables, cable drums, or spring components under tension.
